Jump to content
Forums in Read-Only Mode - Please use Reddit ×
  • 0

About Aver Super 007 used as radio


Sandro

Question

Hi to All

I've an Aver Media Super 00t "hybrid"

ci74771ht ~ # lspci|grep -i vide
06:01.0 Multimedia controller: Philips Semiconductors SAA7131/SAA7133/SAA7135 Video Broadcast Decoder (rev d1)

In DVB mode works fine with "Kaffeine".

 

About "kernel-level configuration, there is all for this device":

ci74771ht ~ # zcat /proc/config.gz |grep SAA7134
CONFIG_VIDEO_SAA7134=m
CONFIG_VIDEO_SAA7134_ALSA=m
CONFIG_VIDEO_SAA7134_RC=y
CONFIG_VIDEO_SAA7134_DVB=m

With Kaffeine in DVB mode de device works very fine.

ci74771ht ~ # dmesg|grep -i firmw
[    7.024635] tda1004x: found firmware revision 29 -- ok
[   51.649550] tda1004x: found firmware revision 29 -- ok
[  245.667589] tda1004x: found firmware revision 29 -- ok
[  447.106576] tda1004x: found firmware revision 29 -- ok
[  661.450135] tda1004x: found firmware revision 29 -- ok
[ 1691.363254] tda1004x: found firmware revision 29 -- ok

Also dmesg tell me:

ci74771ht ~ # dmesg |grep -i "tda\|saa"
[    3.625293] saa7130/34: v4l2 driver version 0, 2, 17 loaded
[    3.625441] saa7133[0]: found at 0000:06:01.0, rev: 209, irq: 16, latency: 32, mmio: 0xf7100000
[    3.625447] saa7133[0]: subsystem: 1461:f01d, board: Avermedia Super 007 [card=117,autodetected]
[    3.625470] saa7133[0]: board init: gpio is 40000
[    3.760848] saa7133[0]: i2c eeprom 00: 61 14 1d f0 54 20 1c 00 43 43 a9 1c 55 d2 b2 92
[    3.760853] saa7133[0]: i2c eeprom 10: ff ff ff ff ff 20 ff ff ff ff ff ff ff ff ff ff
[    3.760856] saa7133[0]: i2c eeprom 20: 01 40 01 32 32 01 01 43 88 ff 00 55 ff ff ff ff
[    3.760860] saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[    3.760876] saa7133[0]: i2c eeprom 40: ff 21 00 c0 96 10 05 32 15 76 8b 0c ff ff ff ff
[    3.760879] saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[    3.760894] saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[    3.760897] saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[    3.760900] saa7133[0]: i2c eeprom 80: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[    3.760903] saa7133[0]: i2c eeprom 90: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[    3.760907] saa7133[0]: i2c eeprom a0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[    3.760910] saa7133[0]: i2c eeprom b0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[    3.760913] saa7133[0]: i2c eeprom c0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[    3.760916] saa7133[0]: i2c eeprom d0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[    3.760920] saa7133[0]: i2c eeprom e0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[    3.760923] saa7133[0]: i2c eeprom f0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
[    3.805917] tda829x 0-004b: setting tuner address to 60
[    3.836971] tda829x 0-004b: type set to tda8290+75a
[    6.815437] saa7133[0]: registered device video1 [v4l2]
[    6.815536] saa7133[0]: registered device vbi0
[    6.823345] DVB: registering new adapter (saa7133[0])
[    6.823348] saa7134 0000:06:01.0: DVB: registering adapter 0 frontend 0 (Philips TDA10046H DVB-T)...
[    6.860395] tda1004x: setting up plls for 48MHz sampling clock
[    7.024635] tda1004x: found firmware revision 29 -- ok
[    7.187710] saa7134 ALSA driver for DMA sound loaded
[    7.187720] saa7133[0]/alsa: saa7133[0] at 0xf7100000 irq 16 registered as card -1
[   51.487341] tda1004x: setting up plls for 48MHz sampling clock
[   51.649550] tda1004x: found firmware revision 29 -- ok
[  245.506372] tda1004x: setting up plls for 48MHz sampling clock
[  245.667589] tda1004x: found firmware revision 29 -- ok
[  446.945321] tda1004x: setting up plls for 48MHz sampling clock
[  447.106576] tda1004x: found firmware revision 29 -- ok
[  661.288904] tda1004x: setting up plls for 48MHz sampling clock
[  661.450135] tda1004x: found firmware revision 29 -- ok
[  736.083919] tda827xa_set_params: could not write to tuner at addr: 0xc0
[ 1691.202036] tda1004x: setting up plls for 48MHz sampling clock
[ 1691.363254] tda1004x: found firmware revision 29 -- ok

Also lsmod I think is good:

ci74771ht ~ # lsmod|grep -i saa
saa7134_alsa           10070  1 
saa7134_dvb            23820  0 
videobuf2_dvb           3550  1 saa7134_dvb
saa7134               155825  2 saa7134_dvb,saa7134_alsa
tveeprom               12673  1 saa7134
videobuf2_dma_sg        3439  2 saa7134_dvb,saa7134
videobuf2_core         20833  4 saa7134_dvb,saa7134,uvcvideo,videobuf2_dvb
snd_pcm                63535  5 snd_usb_audio,snd_hda_codec,snd_hda_intel,snd_hda_controller,saa7134_alsa
snd                    50619  24 snd_hda_codec_realtek,snd_usb_audio,snd_hwdep,snd_timer,snd_pcm,snd_rawmidi,snd_hda_codec_generic,snd_usbmidi_lib,snd_hda_codec,snd_hda_intel,snd_seq_device,saa7134_alsa
ci74771ht ~ # 

The Trouble for me is about use of this card in mode FM radio.

I've installed kradio, bat i don't know ho to configure correctly it; or if there is another software thanx for any suggestion

Link to comment
Share on other sites

0 answers to this question

Recommended Posts

There have been no answers to this question yet

×
×
  • Create New...