Jump to content
Read the Funtoo Newsletter: Summer 2023 ×
  • 0

eth0 does not get IP


bsdtux

Question

Hello funtoo forum, I seem to be having problems with post installation networking. I followed the funtoo installation guide using the debian-sources and universal kernel. I installed NetworkManager and added both networkmanager and dhcpcd default. However I do not get an IP address.

 

I am running this as a virtual machine using virtualbox.

 

nmcli dev status
DEVICE              TYPE                         STATE
eth0                    802-3-ethernet          disconnected
 
nmcli con status
NAME                                UUID                                                                   TYPE                        TIMESTAMP-REAL
Wired connection 1            de1f1889-7e2b-4004-931d-350ba2a42d8b        802-3-ethernet         Mon 03 Nov 2014 08:21:47 AM CST

 

 

dmesg | grep eth0
[ 6.158591] e1000 0000:00:03.0 eth0: (PCI:33MHz:32-bit) 08:00:27:36:2b:0f
[ 6.158596] e1000 0000:00:03.0 eth0: Intel (R) PRO/1000 Network Connection
[ 11.518245] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 11.520493] e1000: eth0 NIC Link is up 1000 Mbps Full Duplex, Flow Control: RX
[ 11.520773] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready

 

can someone please help me figure out what I may have done wrong or might need to add to correct this. I am leaning to the face that I see IPv6 and not IPv4 as being the main culprit here but I could be wrong.

Link to comment
Share on other sites

4 answers to this question

Recommended Posts

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...